Positioning and connecting
en
17
3.
Tighten the lock nut against the
housing.
In doing so, hold the foot tight and
do not adjust its height.
The lock nuts on all four appliance
feet must be screwed tightly against
the housing.
Electrical connection
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
■
Never touch or hold the mains plug
with wet hands.
■
Only pull out the mains cable by the
plug and never by the cable, as this
could damage it.
■
Never unplug the mains plug during
operation.
Observe the following information and
ensure that:
Notes
■
The mains voltage and voltage
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
■
The washing machine is only
connected to an alternating current
via a properly installed earthed
socket.
■
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
installed.
■
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
■
No multiple plugs/couplings or
extension cables are used.
■
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used:
z
.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug must be freely
accessible at all times. If this is not
possible, in order to comply with the
relevant safety regulations, a switch
(2-pole switch-off) must be built into
the permanent installation in
accordance with electrical
installation regulations.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before using the appliance for
the first time
The washing machine was thoroughly
tested before leaving the factory.To
remove any water that may be left over
from the test, run the first wash cycle
without
any laundry.
Notes
■
The washing machine
must be
correctly
installed
and
connected
.
From
■
Never use a machine if it is
damaged. Inform the after-sales
service.
Preparatory work:
1.
Check the machine.
2.
Remove the protective film from the
control panel.
3.
Plug in the mains plug.
4.
Turn on the tap.
Summary of Contents for WAT28780IR
Page 47: ...6 ...