Appliance settings
en
35
Note:
If the
Û
display flashes, this
informs you to run the
Drum Clean
programme or any other programme at
a washing temperature of at least
60 °C.
Removing laundry/switching
off the appliance
1.
Open the loading door and remove
the laundry.
2.
Switch off the appliance.
3.
Turn off the tap.
Note:
Not required for AquaStop
models.
Notes
■
Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■
Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■
Wipe the rubber gasket dry.
■
Leave the washing machine door
and detergent drawer open so that
any residual water can dry away.
■
Always wait for the end of the
programme, otherwise the appliance
may still be locked. Then switch on
the appliance and wait for it to
unlock.
Q
Appliance settings
Appliance settings
You can change the following settings
in the control and display panel:
■
The volume of the information signal
(e.g. at the end of the programme),
■
The volume of the operating signals,
■
The brightness of the operating and
display field,
■
Select/deselect the memory function
for drum care.
You will need to activate the setting
mode in order to change these settings.
Activating the setting mode
1.
Switch on the appliance. The
settings for the current programme
are displayed.
2.
Touch the control panel
œ
.
The setting mode is activated and the
displays for the information signals
U
and the preset volume light up.
You can now change the settings:
Changing the signal volume
To do this, touch
N
or
M
on the control
panel until the required adjustment
value for the volume of the
information
signals
appears:
Adjustment values:
Exit setting mode or:
Touch
œ
again. The display for the
operating signals
C
and the preset
volume light up.
Touch
N
or
M
to change the
adjustment value (as above).
Exit setting mode or:
0
off
1
quiet
2
Medium
3
loud
4
very loud
Summary of Contents for WAT28780IR
Page 47: ...6 ...