en
Faults and what to do about them.
42
Odours in the washing
machine.
Run the
Drum Clean
or
Cottons
90 °C
programme without laundry.
Add standard washing powder or a detergent that contains bleach.
Note:
To prevent foaming, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use detergents intended for woollens or
delicates.
The
Å
indicator has lit
up in the touch display.
Foam may also be leaking
from the detergent
drawer.
Have you used too much detergent?
Mix one tablespoon of fabric softener with half a litre of water and pour it into
compartment
II
(not suitable for outdoor clothing, sportswear or items made
with down).
Use less detergent for the next wash cycle.
Loud noises, vibrations
and machine "wander-
ing" during the spin cycle.
■
Is the appliance level? Level the appliance.
■
Are the appliance's feet secured? Secure the appliance's feet.
■
Have the transport braces been removed? Remove the transport braces.
The touch display does
not work while the appli-
ance is running.
■
Has there been a power failure?
■
Have the fuses blown/has the circuit breaker tripped? Switch on the circuit
breaker/replace the fuses.
■
If the fault occurs repeatedly, call the after-sales service.
There are noises after the
programme starts Active-
Oxygen Refresh
Ø
.
Not a fault – the appliance is filled with water to create mist; operating noises
from the fan and pump can be heard when it is doing this.
Water stains on dry laun-
dry after the ActiveOxy-
gen Refresh
Ø
programme.
■
Was residual water removed before laundry was added?
■
Level the appliance. The active oxygen treatment can only work properly if
the appliance is levelled correctly.
Noises can be heard after
the ActiveOxygen
Refresh
Ø
programme.
Active oxygen leaves a specific odour on the laundry following treatment. Shake
out the laundry briefly.
Odour has not been
removed satisfactorily
after the ActiveOxygen
Refresh
Ø
programme.
■
The active oxygen treatment is less effective if the drum is dirty. Run the
Drum Clean
programme before using the appliance for the first time, and
regularly thereafter.
■
Have you loaded too much laundry? Do not exceed the maximum load.
■
Leave the door and detergent drawer open so that any residual water can
There is detergent resi-
due on the laundry.
■
Some phosphate-free detergents contain water-insoluble residue.
■
Select
Rinse
or brush the laundry after washing.
When the appliance is
paused,
A
flashes and
è
lights up.
■
The water level is too high. It is not possible to add laundry. Close the door
immediately if necessary.
■
Touch
A
to continue the programme.
Faults
Cause/remedy
Summary of Contents for WAT28780IR
Page 47: ...6 ...