Faults and what to do about them.
en
41
è
flashes
■
Slowly: The door cannot currently be locked or unlocked. Waiting time
required.
■
Quickly: Close the door because water can flow out from the laundry.
è
and the ActiveOx-
ygen
Refresh
Ø
indicator
light flash
The door cannot be opened due to programme-related technical reasons.
When the lights go off, the door can be opened.
A
off
At the end of the programme, while the door is open
A
is lit up
After the programme has started
A
is flashing
Before the programme starts, paused
r
is lit up
Water pressure too low, may increase the length of the programme.
r
is flashing
No water supply:
■
Turn the tap on fully,
■
The supply hose is kinked/trapped,
■
Clean the filter if necessary.
E
3s is lit up
The childproof lock is activated – deactivate it.
E
3s is flashing
The childproof lock is activated – the programme selector has been turned or the
control panel touched.
Û
is flashing
Run the
Drum Clean 90 °C
programme or a 60 °C programme to clean and care
for the drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use standard washing powder or a detergent that contains bleach. To prevent
foaming, only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents intended for woollens or delicates.
■
Switching the information signal on/off
Å
is lit up
Too much foam has been detected and additional rinse cycles have been activated.
Add less detergent to the next wash cycle with the same load.
E:60 alternating with
- 2b and
End
At the end of the programme.
Not an appliance fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed.
Distribute small and large items of laundry evenly in the drum. Spin the laundry
again if necessary.
E:35 alternating with
- 10
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
E:36 alternating with
- 10
■
The drain pump is blocked. Clean the drain pump.
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
Other indicators
Switch off the appliance, wait for five seconds and then switch it on again. If the indi-
cator appears again, call the after-sales service.
Indicator
Cause/remedy
