Bosch WAT28799HK, Instruction Manual And Installation Instructions

Operating the appliance       

en

33

Information on the following programme 

steps and settings, which can be 

changed during the programme 

sequence, light up at half brightness.

Note:  

Foam detection

If the 

Å

 display also lights up, the 

washing machine has detected too 

much foam during the washing 

programme and automatically activated 

additional rinse cycles to remove the 

foam.

Add less detergent to the next washing 

cycle with the same load.

If you want to lock the programme to 

prevent it from being inadvertently 

adjusted, you can select the childproof 

lock as follows.

Childlock/operation lock

E

 3 sec

You can lock the washing machine to 

prevent the functions you have set from 

being changed inadvertently in the 

control panel.
To 

activate

/deactivate the 

childproof 

lock

, touch and hold the control panel 

E

 3 sec for approx. three seconds. The 

display switches to full brightness.
If you turn the programme selector or 

touch the control panel while the 

childproof lock is active, the 

E

 3 sec 

indicator flashes briefly and a signal 

sounds. The programme runs through 

to the end unchanged.

Notes

■

The childproof lock can be activated 

regardless of the appliance's status.

■

The childproof lock remains active, 

even once the washing machine has 

been switched off. 

■

If the appliance is switched off while 

the programme is running and the 

childproof lock has been activated, 

the programme will resume when the 

appliance is switched back on.

Adding laundry

After starting the programme, you can 

add or remove laundry if necessary.
To do this, touch the control panel 

A

. 

The indicator flashes. The machine is 

paused and checks whether it is 

possible to add laundry. 
If the display 

è

 goes out, it is possible 

to add laundry. The door is then 

unlocked and can be opened.

To continue the programme. touch

A

again. The programme continues 

automatically.

Notes

■

Do not leave the door open for too 

long when adding laundry as water 

from the laundry may leak out.

■

For safety reasons, the door remains 

locked when the water level or 

temperature is high, or while the 

drum is turning, and it is not possible 

to add laundry during this time. 

Follow the information on the display 

panel.

■

It is not possible to add laundry 

during the ActiveOxygen Refresh 

Ø

programme or when the 

ActiveOxygen setting has been 

selected. 

■

The load display is not active during 

reloading.

Changing the programme

If you have started the wrong 

programme by mistake, you can 

change the programme as follows:

1.

Touch the control panel 

A

.

2.

Select another programme.

3.

And touch 

A

 again.The new 

program starts from the beginning.

Note:  

When cancelling programmes 

that use active oxygen, the door will 

remain locked for up to 25 minutes until 

there is no longer any active oxygen in 

the drum.