en
operation
32
▶
Adjust the programme settings.
→
Observe the information about op-
erating logic →
.
Notes
¡
The programme settings are not
saved permanently for the pro-
gramme.
¡
The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
¡
A programme is set.
→
"Setting a programme", Page 31
¡
The programme settings have
been adjusted.
→
▶
Press and hold for approx. 3
seconds.
Press to call up the saved pro-
gramme.
Note:
To overwrite the saved pro-
gramme, repeat the steps above.
13.5 Loading laundry
Note:
To prevent creasing, note the
maximum load for the programmes.
→
Requirements
¡
The laundry is prepared and sor-
ted.
→
¡
The drum is empty.
1.
Open the door.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
13.6 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip:
In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note:
Observe the information about
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.7 Starting the programme
Requirement:
A programme is set.
"Setting a programme", Page 31
▶
Press
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows:
End
.