Intelligent dosing system
en
35
15.2 Filling the dispensers
If you want to use the intelligent dos-
ing system or if the appliance dis-
plays a notification during operation
of the appliance, fill the dispensers.
Note:
Fill the dispensers only with
suitable detergent and care products
→
If you want to add more liquid deter-
gent or fabric softener in the dis-
penser, use the same product.
If you want to replace the liquid de-
tergent or fabric softener in the dis-
penser with another product, clean
the detergent drawer beforehand.
→
"Cleaning the detergent drawer",
If you want to use both dispensers
for liquid detergent, adjust the con-
tents of the dispensers →
.
Requirement:
The display shows a
notification to fill the dispenser.
→
1.
Pull out the detergent drawer.
2.
Open the dispenser cover.
3.
Pour liquid detergent and fabric
softener into the relevant dis-
pensers.
→
Do not exceed the marking for the
maximum fill level when filling.
4.
Close the dispenser cover.
Note:
To prevent the liquid deter-
gent or fabric softener from drying
out, close the dispenser cover im-
mediately after filling.
5.
If required, pour washing aid into
the compartment for manual dos-
ing.
→
6.
Push in the detergent drawer.
7.
15.3 Dispenser contents
Notes
¡
If you change the contents of the
dispenser, the basic dosage for
this dispenser is reset.
¡
If you use both dispensers for li-
quid detergent, you must select a
dispenser which is to be used dur-
ing washing.
Adjusting the dispenser contents
1.
Press and hold
i-DOS
for ap-
prox. 3 seconds.
