NLSet up and connect
WARNING
Risk of injury!
When used on a plinth, the device can
tip over.
▶
The device feet for commissioning
on a plinth must be absolutely
with the fixings
Page 30from the manufacturer.
installation site
kitchen
Requirements
The device al-
borrow under a
continuous work
place sheet,
that fixed with the
adjacent
cabinet is connected
Pine tree. Required
niche width:
60 cm.
PAY ATTENTION!
Freezing residual water in the device
can damage the device.
▶
Do not place and use the device in
frost-sensitive places or outdoors.
If the device is tilted more than 40°,
residual water can run out of the
device and cause material damage.
▶
Carefully tilt the device.
▶
Transport the device upright.
on a wall
no snakes
between wall and
clamping device
man.
4.4 Removing transport locks
The device is secured for transport
with transport locks at the rear of the
device.
installation site
Plinth
Requirements
The device with
confirm.
Remark:Keep the screws of the
transport locks and the sleeves for
later transport
1.
Pull the hoses out of the holders.
Floor with wooden
beams
Place the device
guess at a
resistant
wooden plate (thick-
too minimal
30mm) which
screwed to the
floor.
14