NLSet up and connect
1.
Connect the water inlet hose to the
tap (26.4 mm = 3/4").
plastic stand
pipe with rubber
run muff or a
floor drain
the water
feeding hose with
a bend
fixate and
gene.
4.6 Adjusting the device
To reduce noises and vibrations and to
prevent the device from walking, place
the device horizontally.
1.
Loosen the lock nuts with a SW17
open-end wrench.
2.
Open the tap carefully and check
that the connections are tight.
Connection types for water drainage
The information will help you to connect
this appliance to the water outlet.
PAY ATTENTION!
When draining, the water drain hose is
under pressure and can come loose
from the installed connection position.
▶
Secure the water drain hose against
unintentional disconnection.
Remark:Observe the pumping
heights.
The maximum pumping height bed
The connection position
tie with a
hose clamp
(24-40 mm) bore
gene.
washbasin
the water
feeding hose with
a bend
honor and
n.
fix
ge
16