en
Troubleshooting
48
Fault
Cause
Troubleshooting
"E:36 / -25 / -26"
Drain pump is blocked.
▶
The water pressure is low.
No remedial action possible.
The filters in the water inflow
are blocked.
▶
"Clean the filters in the water in-
flow"
.
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is
kinked or jammed.
▶
Ensure that the water inlet hose is
not kinked or jammed.
flashes.
The automatic voltage con-
trol system detects an unau-
thorised voltage under-us-
age.
▶
No remedial action possible.
Note:
If the power supply is stable, the
programme continues to run as nor-
mal.
Voltage under-usage may
cause extension of a pro-
gramme.
No remedial action possible.
flashes.
Voltage under-usage may
cause extension of a pro-
gramme.
No remedial action possible.
lights up.
The temperature is too high.
▶
Wait until the temperature has
dropped.
▶
Water level is too high.
▶
Start the
Drain
programme.
Laundry is caught in the
door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press
Start/Reload
to start the pro-
gramme.
flashes.
Door is not closed.
1.
Close the door.
2.
Press
Start/Reload
to start the pro-
gramme.
All other error codes.
Malfunction
▶
Call the after-sales service.
The appliance is not work-
ing.
The mains plug of the power
cord is not plugged in.
▶
Connect the appliance to the power
supply.
The circuit breaker is faulty.
▶
Check the circuit breaker in the
fuse box.