Basic operation
en
37
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows: End.
Adjusting the "Ready in" time
before the programme starts
You can readjust the selected "Ready
in" time before the programme starts.
1.
Press
Start/Reload
.
2.
Press
Finish in
repeatedly until the
display indicates the desired
"Ready in" time.
3.
Press
Start/Reload
.
Adding laundry
Note:
Please read the information in
the "Safety" →
sec-
tions to ensure that you use the appli-
ance safely.
1.
Press
Start/Reload
.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
Start/Reload
.
Cancelling the programme
Once the programme has started,
you can cancel it at any time.
Note:
Please read the information in
the "Safety" →
sec-
tions to ensure that you use the appli-
ance safely.
1.
Press
Start/Reload
.
2.
Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse
programme.
– If the water level is high: Start
the
Spin
or
Drain
programme.
3.
Remove the laundry.
Resuming the programme
when the programme status
is Rinse Hold
1.
Set the
Spin
or
Drain
programme.
2.
Press
Start/Reload
.
Unloading the laundry
Note:
Please read the information in
the "Safety" →
sec-
tions to ensure that you use the appli-
ance safely.
1.
Open the door.
2.
Remove the laundry.