en
Troubleshooting
54
Fault
Cause
Troubleshooting
The spin result is not satis-
factory. The laundry is too
wet/too damp.
A low spin speed is selected.
▶
The next time you run a wash cycle,
set a higher spin speed.
▶
Start the
Centrifugering
pro-
gramme.
is activated.
▶
Select the programmes that are
suitable for the type of fabric.
Drain pipe or water outlet
hose is blocked.
▶
Clean the drain pipe and the water
outlet hose.
Drain pipe or water drain
hose is caught or jammed.
▶
Ensure that the drain pipe and wa-
ter drain hose are not kinked or
trapped.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the
drum.
Note:
Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
▶
Start the
Centrifugering
pro-
gramme.
Unbalance load detection
system is using a reduced
spin speed to eliminate an
unbalance.
▶
Redistribute the laundry in the
drum.
Note:
Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
▶
Start the
Centrifugering
pro-
gramme.
Detergent residue on the
damp washing.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
▶
Start the
Sköljning
programme.
Detergent residue on the dry
laundry.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
▶
Brush out the laundry after washing
and drying.
Water is leaking out at the
water inlet hose.
Water inlet hose is not cor-
rectly/securely connected.
1.
Connect the water supply hose cor-
rectly. Connecting the water inlet
hose
2.
Tighten the screw connection.
Water is leaking out at the
water outlet hose.
The water outlet hose is
damaged.
▶
Replace the damaged water outlet
hose.