en
Faults and what to do about them.
30
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any programme
(except Rinse/Spin/Empty).
3.
Press the
A
button. Allow the
programme to run for approximately
40 seconds.
4.
Press the
#
button. The appliance is
switched off.
5.
Pull out the mains plug.
Then clean the filter:
1.
Disconnect the hose from the tap.
Clean the filter with a small brush.
2.
For standard and Aqua-Secure
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
3.
Connect the hose and check for
leaks.
3
Faults and what to do
about them.
Faults and what to do about them.
Emergency release
E.g. in the event of a power cut
The programme continues when the
power supply is restored.
However, if the laundry has to be
removed, the washing machine door
can be opened as follows:
:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
and laundry.
If possible, leave it to cool down first.
:
Warning
Risk of injury!
You may injure your hands if you reach
into the drum while it is turning.
Do not reach into the drum when it is
turning.
Wait until the drum has stopped turning.
Caution!
Water damage
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
1.
Switch off the appliance. Pull out the
mains plug.
2.
Drain the water
3.
Pull the emergency release
downwards with a tool and release.
The door can then be opened.
