Bosch WAW285H1UC, Use And Care Manual / Installation Instructions

12

INSTALLATION INSTRUCTIONS

Installation instructions 

9

WARNING

RISK OF FIRE, ELECTRICAL SHOCK OR INJURY 

TO PERSONS
To reduce the risk of fire, electric shock or injury to 

persons, read the Important Safety Instructions at 

the front of this manual before installing or operating 

this appliance.

9

CAUTION

THE APPLIANCE IS HEAVY

▯

Use additional help and care when lifting and 

positioning.

▯

REMOVE ALL TRANSPORT BOLTS BEFORE 

OPERATING WASHER. Washer will vibrate and 

could cause damage if transport bolts are not 

removed before use.

Introduction

Read these installation instructions completely and 

carefully before starting to install your new washing 

machine. The information contained can save time and 

effort and will help to ensure optimum performance of 

your new washer. Be sure to observe all warnings and 

cautions.

NOTICES

▯

Frozen hoses can tear or burst. Do not install the 

washing machine outdoors or in an area exposed to 

freezing conditions.

▯

If the washing machine is located in a room which will 

be exposed to temperatures below freezing, or if it is 

located in a cabin that is being shut down for the 

winter, any residual water in the pump or water inlet 

hose(s) must be drained.

▯

Take care not to damage the washing machine. Do 

not hold on to protruding parts (e.g. door) when lifting. 

Do not push against the appliance door glass due to 

risk of damage.

▯

In addition to the safety information listed here, the 

local water and electric authorities may have special 

requirements that must be followed.

▯

If in doubt, have the appliance installed by an 

authorized service provider.

▯

Hidden surfaces may have sharp edges. During 

service wear gloves and use caution when reaching 

inside the washer housing.

These installation instructions are intended for use by 

qualified installers. In addition to these instructions, the 

installation must comply with:
- for the United States - National Electrical Code, ANSI/

NFPA70 - and latest editions of the state and municipal 

and/or local regulations.
- for Canada - Canadian Electrical Code C22.1 - and the 

latest editions of the provincial, municipal and/or local 

regulations.

Tools needed

The following tools may be helpful during installation of 

your washer.

▯

13mm socket for removing the transport bolts.

▯

17mm wrench for adjusting the appliance feet.

▯

Bubble level for leveling the appliance.

Waste disposal

Disposal of Packaging Materials

After unpacking your new appliance dispose of the 

protective packaging materials in an environmentally 

friendly way. Ask your dealer or inquire with your local 

authority regarding currently acceptable means of 

disposal.

9

WARNING

WARNINGS FOR CHILDREN
Do not let children play with packaging and 

associated parts to avoid risk of choking or 

suffocation.

Disposal of Your Old Appliance

Your old appliance can be recycled if it is no longer to be 

used. Prior to disposing of your old appliance observe 

the following precautions to reduce safety risks.

9

WARNING

TO AVOID RISK OF INJURY OR DEATH, DO THE 

FOLLOWING
- after unplugging the old appliance, remove the 

electric power cord and dispose of properly.
- remove the door or permanently disable the door 

lock to prevent children from being locked inside.