Home Connect
en
49
8.
Carry out the steps in the
Home Connect app to connect the
appliance.
a
If the display shows
Connected
and
lights up permanently, the
appliance is connected to the
home network.
9.
"Connect your appliance to the
Home Connect app" →
.
Connecting your appliance to
the Home Connect app
Requirements
¡
The appliance is connected to the
WLAN home network (Wi-Fi).
¡
The Home Connect app is open
and you have logged on.
1.
Select
Connect app
.
2.
Select
Connect to the app
.
3.
Confirm the message in the dis-
play.
a
The appliance connects to the
Home Connect app.
4.
Once your appliance is displayed
in the Home Connect app, carry
out the last steps in the
Home Connect app.
a
If the display shows
Connected
,
the appliance is connected to the
Home Connect app.
Connecting the appliance to
the energy manager
If you connect the appliance to the
smart energy system (energy man-
ager), you will optimise your energy
consumption. The appliance starts
only when your home photovoltaic
system can provide sufficient energy
or the energy tariff is good.
Requirements
¡
The smart energy system (energy
manager) must use the EEBus Initi-
ative communications standard.
¡
You have read about how to con-
nect your appliance to the smart
energy system (energy manager)
in the instruction manual for the
smart energy system (energy man-
ager).
1.
Press and hold
Απομακρυσμένη έναρξη
for
approx. 3 seconds.
2.
Select
energy mngmt.
.
3.
Select
Connect
.
4.
Confirm the message in the dis-
play.
a
The appliance is connected to the
smart energy system (energy man-
ager)
a
If the appliance has connected to
the energy manager successfully,
the display shows .
5.
Activate Flex Start if you want the
smart energy system (energy man-
ager) to start up your appliance.
→
"Activate Flex Start", Page 49
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to
provide sufficient energy or the en-
ergy tariff is good.
Requirement:
The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
1.
Set the programme you require.
2.
Press
Λήξη σε
to set the required
time.