en
Basic operation
50
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.7 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press
Start/Reload
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
13.8 Adding laundry
Note:
Please read the information in
the Safety →
sections
to ensure that you use the appliance
safely.
1.
Press
Start/Reload
.
The appliance is paused and
checks whether it is possible to
add or remove laundry.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
Start/Reload
.
13.9 Cancelling the pro-
gramme
Once the programme has started,
you can cancel it at any time.
Note:
Please read the information in
the Safety →
sections
to ensure that you use the appliance
safely.
1.
Press
Start/Reload
.
2.
Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the
Rinse/Freshen Up
pro-
gramme.
– If the water level is high: Start
the
Spin
or
Drain
programme.
3.
Remove the laundry.
13.10 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
1.
Set the
Spin
or
Drain
pro-
gramme.
2.
Press
Start/Reload
.
13.11 Unloading the laundry
Note:
Please read the information in
the Safety →
sections
to ensure that you use the appliance
safely.
1.
Open the door.
2.
Remove the laundry.
Summary of Contents for WAX28EH1GB
Page 65: ...Cleaning and servicing en 65 3 Connect the water inlet hose and check for leaks ...
Page 81: ......
Page 82: ......
Page 83: ......