en
Basic operation
42
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent to the manual
dosing compartment.
Note:
Please read the information in
the Safety →
sections
to ensure that you use the appliance
safely.
Tip:
In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Requirement:
Find out the optimum
dosage for detergent and care
product. →
1.
Pull out the detergent drawer.
2.
Pour in detergent.
→
3.
If required, add the care product.
4.
Push in the detergent drawer.
13.6 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press
Start/Reload
.
a
The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows:
-0-
.
13.7 Soaking laundry
Note:
No additional detergent is re-
quired. The washing solution is then
used for washing.
1.
Start the programme.
2.
To pause the programme, after ap-
prox. 10 minutes, press
Start/Re-
load
.
3.
To resume the programme, after
the desired soaking time, press
Start/Reload
.
13.8 Adding laundry
Note:
Please read the information in
the Safety →
sections
to ensure that you use the appliance
safely.
1.
Press
Start/Reload
.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
2.
Add or remove laundry.
3.
Close the door.
4.
Press
Start/Reload
.
13.9 Cancelling the pro-
gramme
Once the programme has started,
you can cancel it at any time.
Note:
Please read the information in
the Safety →
sections
to ensure that you use the appliance
safely.
1.
Press
Start/Reload
.
2.
Open the door.