en
Before using for the first time
20
Before using for the first time
6 Before using for the
first time
Before using for the first time
Prepare the appliance for use.
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
1.
Press .
The switch-on process takes a few
seconds.
2.
Set the
Drum Clean
pro-
gramme.
3.
Close the door.
4.
Pull out the detergent drawer.
5.
Add washing powder to the
manual dosing compartment.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
6.
Push in the detergent drawer.
7.
Press
Start/Reload
to start the
programme.
a
The display shows the remaining
programme duration.
a
After the programme has ended,
the display shows:
-0-
.
8.
Start the first wash cycle or press
to switch off the appliance.
