en
Home Connect
38
2.
Press
Start/Reload
.
a
The appliance connects to the
Home Connect app.
3.
Once your appliance is displayed
in the Home Connect app, carry
out the last steps in the
Home Connect app.
a
If the display shows
con
, the appli-
ance is connected to the
Home Connect app.
16.4 Activating Wi-Fi on the
appliance
Note:
When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
1.
Press and hold
Remote Start
for
approx. 3 seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start/Reload
repeatedly
until the display shows
On
.
a
Wi-Fi is activated.
Note:
If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
16.5 Deactivating Wi-Fi on the
appliance
1.
Press and hold
Remote Start
for
at least three seconds.
2.
Set the programme to position 4.
a
The display shows
Con
.
3.
Press
Start/Reload
repeatedly
until the display shows
OFF
.
a
Wi-Fi is deactivated.
Note:
The connection is automatically
re-established when the Wi-Fi is
switched back on.
16.6 Resetting the appliance
network settings
1.
Press and hold
Remote Start
for
at least 3 seconds.
2.
Set the programme to position 5.
a
The display shows
rES
.
3.
Press
Start/Reload
.
a
The display shows
YES
.
4.
Press
Start/Reload
.
a
The network settings are reset.
a
If
End
is shown on the display, the
network settings are reset.
16.7 Remote start
Enable the appliance for remote start
via the Home Connect app.
Activating remote start
Notes
¡
Remote start is deactivated for
safety reasons in the following
circumstances:
–
Open the appliance door.
–
Press
Start/Reload
.
–
Press
Remote Start
.
–
Switch off the appliance.
–
Following a power cut.
¡
Remote start cannot be activated
for safety reasons in the following
circumstances:
–
The appliance door is open.
–
The detergent drawer has not
been pushed in fully.
Requirements
¡
The appliance is connected to your
Wi-Fi home network.
¡
The appliance is connected to the
Home Connect app.
¡
A programme is selected.
▶
Press
Remote Start
.
If you press and hold the button
for at least 3 seconds, the
Home Connect menu opens.