Troubleshooting
en
43
Fault
Cause and troubleshooting
lights up.
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
"Cancelling the programme", Page 31
Water level is too high.
▶
Select a suitable programme for draining.
→
Laundry is caught in the door.
1.
Open the door again.
2.
Remove any trapped laundry.
3.
Close the door.
4.
Press
Start/Reload
to start the programme.
flashes.
Door is not closed.
1.
Close the door.
2.
Press
Start/Reload
to start the programme.
All other error codes.
Malfunction
▶
Call the after-sales service.
→
"E:30/-20"
Solenoid valve defective.
▶
Call the after-sales service.
→
Detergent dosage is too high.
▶
Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water is added.
▶
Do not add any extra water to the appliance while it
is operating.
The appliance is not
working.
The mains plug of the power cord is not plugged in.
▶
Connect the appliance to the power supply.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The programme does
not start.
You have not pressed
Start/Reload
.
▶
Press
Start/Reload
.
Door is not closed.
1.
Close the door.
2.
Press
Start/Reload
to start the programme.
Childproof lock is activated.