en
Cleaning and servicing
56
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon is
dirty or the detergent solution is not be-
ing pumped out, you must clean these.
1.
Switch off the appliance.
2.
Disconnect the appliance's mains
plug from the power supply.
3.
Loosen the hose clamp and carefully
remove the water outlet hose.
Residual water may leak out.
4.
Clean the water outlet hose and si-
phon connecting piece.
5.
Reattach the water outlet hose and
secure the connection point using
the hose clamp.
Cleaning the water inlet filter
Clean the filter in the water inlet in the
event of blockages or if the water pres-
sure is too low.
Emptying the water inlet hose
In order to clean the filter, first empty
the water inlet hose.
1.
Turn off the tap.
2.
Set the
Cotton
programme.
3.
Start the programme and leave it to
run for approx. 70 seconds.
4.
Switch off the appliance.
5.
Disconnect the appliance's mains
plug from the power supply.
Cleaning the filter on the tap
Note:
Please read the safety informa-
the appliance safely.
Requirement:
The water inlet hose is
empty.
1.
Remove the water inlet hose from
the tap.