en
Troubleshooting
50
Fault
Cause and troubleshooting
The programme does
not start.
3.
If this display appears again, call customer service.
→
Note:
You can start the washing programme if you de-
activate the intelligent dosing system and dose manu-
ally.
→
The door cannot
be opened.
is activated.
▶
Continue the programme by selecting
Spin
or
Drain
and pressing
.
"Resuming the programme when the programme
status is Rinse Hold", Page 34
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
"Cancelling the programme", Page 33
Water level is too high.
▶
Select a suitable programme for draining.
→
Power failure.
▶
Open the door using the emergency release.
→
The water is not drain-
ing.
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
Drain pump is blocked.
▶
"Cleaning the drain pump", Page 42
is activated.
▶
Continue the programme by selecting
Spin
or
Drain
and pressing
.
"Resuming the programme when the programme
status is Rinse Hold", Page 34
The water outlet hose is connected too high.
▶
Install the water outlet hose at a maximum height of
1 metre.
Pump cover is not correctly assembled.
▶
Correctly assemble the pump cover.
Detergent dosage is too high.
Summary of Contents for WAXH2KI0SN
Page 2: ...https digitalguide bsh group com mat no 9001660897 ...
Page 63: ......