en
Intelligent dosing system
46
When the appliance is switched on, the
following indicates that the detergent
drawer is closed completely:
■
The corresponding illuminated
display on the drawer handle lights
up when intelligent dosing i-DOS is
selected
■
The display flashes once and then
goes out if intelligent dosing is not
selected.
Everyday use
Illuminated displays on the drawer
handle:
■
The display
lights up
if intelligent
dosing is selected for the
corresponding dispenser:
–
w
for dispenser
ß
(detergent),
– for the
i
I
w
illuminated display for
the combined compartment
i
/
ß
, the lamp for the appropriate
dispenser content lights up:
i
for fabric softener/
w
for
detergent.
■
The display
flashes
if the fill level of
the selected intelligent dosing
dispenser is below the minimum
level.
(De)selecting intelligent dosage and
adjusting the dosage strength:
The intelligent dosages for detergent
and fabric softener are set at the factory
for programmes in which intelligent
dosing can be used.
Overview of programmes
The dosage strength has been preset to
low (lightly soiled laundry) for
detergent
w
and to medium (medium
level of softness) for fabric softener
i
. It
can be changed for each programme.
In addition to intelligent dosing, cleaning
aids (e.g. stain remover) can be added
manually to compartment
v
u
, if
Note:
Depending on the programme,
the selection (on/off) as well as the
relevant dosage strength that has been
selected for i-DOS
i
I
w
and i-DOS
w
are saved until they are changed, even
when the machine is switched off.
Topping up the detergent/ fabric
softener:
If, while intelligent dosing is selected,
the respective illuminated display
flashes and there is corresponding
information on the display panel, this
indicates that the minimum fill level has
not been reached. The content is
sufficient for approx. 3 washes.
The same detergent or fabric softener
can be added at any time. If you change
product/manufacturer, we recommend
that you clean the dispensers first.
If required, adjust the basic dosage.
