en
Faults and what to do about them.
64
Information on the display panel
Display
Cause/remedy
Top up the i-DOS
i
I
w
,
w
container
The i-DOS dispensers are below the minimum fill level; top up
i-DOS
i
I
w
, i-DOS
w
error;
Deactivate i-DOS
i
I
w
, i-DOS
w
Set i-DOS
i
I
w
, i-DOS
w
to
Off
.
Call the after-sales service. The appliance can still be operated using manual
dosing. Manual dosing
Close the detergent
drawer
Push the detergent drawer in correctly.
Pause: Reload is not
possible
Temperature or water level is too high. Press the
A
button to continue the
programme.
Door cannot be
unlocked: Water level
or temperature is too
high
Temperature or water level is too high. Press the
A
button to continue the
programme.
The door cannot be
locked; open the door
again, then close it
and press the
A
button
■
Laundry may be caught. Open and close the door again and press the
A
button.
■
If necessary, push the door closed or remove some laundry and then push it
closed again.
■
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
Turn on the tap
■
Turn the tap on fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter.
Clean the drain pump
■
The drain pump is blocked. Clean the drain pump.
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
AquaStop has been
activated. Call the
after-sales service
Not applicable on models without AquaStop
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
Auto power-off in ...
seconds,
Appliance automatically switches off after ... seconds if it is not operated for a
prolonged period. To cancel, press any button.
Water cooling
To protect the wastewater pipes, the hot detergent solution is cooled before being
drained.