en
Appliance settings
50
Q
Appliance settings
Appliance settings
Automatic switch-off
If the appliance is not operated for
approx. 5 minutes (depending on the
water level inside of appliance), it will
automatically switch off before the
programme starts or after the
programme has ended. Press the
power button
#
again to switch on the
appliance.
Note:
If Wi-Fi is switched on at the
appliance, when it is in Energy saving
mode, the appliance will not
automatically switch itself off.
Basic settings
To access the basic settings, touch and
hold the
Á
(Silent)
button for approx. 3
seconds. The control panel show:
You can change the following basic
settings:
■
The volume of the end signal.
■
The volume of the buttons.
■
The brightness of the Touch-Display.
■
Switching the
Û
Limp. tambor
(Drum Clean) information signal on/
off.
End signal
You can select position
1
and use the
˜
button to adjust the volume of the
end signal, e.g.
‘
-
„
.
Possible setting values:
Button signal
You can select position
2
and use the
˜
button to adjust the volume of the
button signal, e.g.
›
-
„
.
Possible setting values:
0
off
1
quiet
2
medium
3
loud
4
very loud
0
off
1
quiet
2
medium
3
loud
4
very loud
