en
Cleaning and maintenance
52
Appliance housing/control
panel
■
Remove the detergent residue
immediately.
■
Wipe the housing and the control
panel with a soft, damp cloth.
■
Do not use abrasive cloths, sponges
or detergents (stainless steel
cleaner).
■
Do not clean the appliance with a
water jet.
Drum
:
Warning
Risk of injury/material damage/
damage to the appliance!
Permanently washing at low
temperatures and a lack of ventilation
for the appliance may damage the drum
and cause injury.
Regularly run a programme for cleaning
the drum or wash at temperatures of at
least 60ºC.
Leave the appliance to dry after every
operation with the door open, and leave
the detergent drawer to dry.
Use chlorine-free cleaning agents, do
not use steel wool.
If there are odours in the appliance, or
to clean the drum, run the
Û
Limp.
tambor (Drum Clean) 90°C
programme
without laundry.
Descaling
Descaling should not be necessary if
the detergent is measured out correctly.
However, if it is required, follow the
manufacturer's instructions for the
descaling agent. Suitable descalers can
be obtained via our website or from
customer services.
Detergent drawer and housing
If the appliance contains detergent or
fabric softener residues:
1.
Pull out the detergent drawer. Press
down the insert and fully remove the
drawer.
2.
To remove the insert: Push the insert
upwards from below with your finger.
3.
Clean the detergent dispenser tray
and insert with water and a brush,
and dry it. Clean the inside of the
housing as well.
