Fixing minor faults yourself
Grey residue on washing
For contamination caused by ointments, grease
or oil, the normal does is sometimes is not
enough. Increase the dosage during the next
wash.
Remedy:
Select
a
maximum
allowable
temperature for the fabrics.
Grey stains on the laundry
These stains may be caused by cosmetics or
fabric softener and have reached already before
washing outside the device to the laundry.
Remedy: after soaking in liquid detergents, some
stains can wash out again.
Foam escapes from the detergent drawer
Too much detergent has been used. Turn the
device off for 5-10 minutes using the "On / Off"
button. As the foam dissipates, place a
tablespoon of fabric softener with 1/2 litre of
water mixed type in the detergent drawer. At
the next wash cycle, adjust the dose of
detergent.
After the last rinse, foam can be seen
Washing items individually may lead to excessive
foaming; however, this has no effect on the
rinsing result.
Motor noise
No mistake! In the running-in phase, the drive
motor can cause noise during operation.
Repeated spinning
The fuzzy-controlled imbalance control system
has detected an imbalance. This is removed by
washing several times.
The IVS-spin (spin interval) was set at the speed
selector.
Vibration during washing and spinning
Transport brackets are not removed. Notes in
the corresponding installation instructions!
Feet were not fixed during installation. Align the
unit with a spirit level and re-secure the feet as
per set-up instructions.
Program time extension
When too much foam exists, the foam detection
has an extra rinse cycle and an additional spin
switched
to
improve
the
wash
results.
With strong imbalances during spinning program
time extensions may occur by repeatedly
distributing the laundry. Remedy: Wash large
and small pieces together in order to reduce the
imbalance.
Summary of Contents for WFF 16 series
Page 1: ......
