en
Cleaning and servicing
46
5.
Reattach the water outlet hose and
secure the connection point using
the hose clamp.
Clean the water inlet filters.
Clean the filter in the water inlet in
the event of blockages or if the water
pressure is too low.
Emptying the water inlet hose
1.
Turn off the tap.
2.
Set a programme, except for
Rinse
فطش
,
Spin
رصع
or
Drain
غيرفت
.
3.
Start the programme and leave it
to run for approx. 40 seconds.
4.
Switch off the appliance.
5.
Disconnect the appliance's mains
plug from the power supply.
Cleaning the filter on the tap
Note:
Please read the information in
the "Safety" →
sec-
tions to ensure that you use the appli-
ance safely.
Requirement:
The water inlet hose is
empty.
1.
Remove the water inlet hose from
the tap.
2.
Clean the filter with a small brush.
3.
Connect the water inlet hose and
check for leaks.