en
first time
24
first time
6 Before using for the
first time
first time
Prepare the appliance for use.
6.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
1.
Turn the programme selector to
Drum Clean
.
2.
Close the door.
3.
Pull out the detergent drawer.
4.
Pour approx. 1 litre of tap water
into compartment II.
5.
Pour standard washing powder
into compartment II.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
6.
Push in the detergent drawer.
7.
Press
Start/Reload
to start the pro-
gramme.
a
The display shows the remaining
programme duration.
a
After the programme has ended,
the display shows: "End" .
8.
Start the first wash cycle or set the
programme selector to
Off
to
switch off the appliance.
→
