en
Troubleshooting
44
Fault
Cause and troubleshooting
The length of the pro-
gramme changes dur-
ing the drying cycle.
The programme operation is optimised electronically.
This may change the programme duration.
▶
Not a fault – no action required.
Pumping noise.
Condensation pump active.
▶
Not a fault – normal operating noise.
Buzzing noise.
Compressor ventilation active.
▶
Not a fault – normal operating noise.
The drying time is too
long.
Fluff filter is soiled.
▶
"Cleaning the fluff filter", Page 29
The ambient temperature is greater than 30 °C.
▶
Ensure that the ambient temperature is lower than
30 °C.
The ambient temperature is lower than 15 °C.
▶
Ensure that the ambient temperature is above 15
°C.
Insufficient air circulation at the appliance's installation
location.
▶
Ventilate the appliance's installation location.
Appliance air inlet is blocked.
▶
Ensure that the air inlet on the appliance is kept
clear.
Heat exchanger is soiled.
▶
"Running the basic appliance care programme
Automatic self-cleaning function rinses the appliance's
heat exchanger.
1.
Not a fault.
2.
Do not pull out the condensation tank.
3.
Do not cancel the programme.
Water is leaking from
the appliance.
Appliance is not correctly aligned.
▶
"Aligning the appliance", Page 13
The seal for the heat exchanger cover is dirty.
▶
Clean the seal for the heat exchanger cover.
→
"Cleaning the base unit", Page 39
The lever for the heat exchanger cover is not closed
correctly.
▶
Ensure that the lever for the heat exchanger cover
is closed correctly.
→
Summary of Contents for WQG23508GR
Page 51: ......