Troubleshooting
en
43
Fault
Cause and troubleshooting
The programme does
not start.
You have not pressed
Start/
Reload
.
▶
Press
Start/
Reload
.
No programme set.
1.
"Setting a programme", Page 30
.
2.
"Starting the programme", Page 30
The length of the pro-
gramme changes dur-
ing the drying cycle.
The programme operation is optimised electronically.
This may change the programme duration.
▶
Not a fault – no action required.
Pumping noise.
Condensation pump active.
▶
Not a fault – normal operating noise.
Buzzing noise.
Compressor ventilation active.
▶
Not a fault – normal operating noise.
The drying time is too
long.
The base unit's filter is soiled.
▶
"Cleaning the filter system on the base unit",
Fluff filter is soiled.
▶
"Cleaning the fluff filter", Page 31
The ambient temperature is greater than 30 °C.
▶
Ensure that the ambient temperature is lower than
30 °C.
The ambient temperature is lower than 15 °C.
▶
Ensure that the ambient temperature is above 15
°C.
Insufficient air circulation at the appliance's installation
location.
▶
Ventilate the appliance's installation location.
The appliance's ventilation opening is blocked.
▶
Ensure that the ventilation opening of the appliance
is kept clear.
Heat exchanger is soiled.
1.
"Opening the base unit", Page 37
2.
Clean the heat exchanger.
→
"Cleaning the base unit", Page 38
3.
"Closing the base unit", Page 39
Water is leaking from
the appliance.
Appliance is not correctly aligned.
▶
"Aligning the appliance", Page 16
The seal for the heat exchanger cover is dirty.
Summary of Contents for WQG24200SG
Page 40: ...en Cleaning and servicing 40 2 Clean the moisture sensor with a sponge ...
Page 49: ......
Page 50: ......
Page 51: ......