operation
en
31
12.4 Starting the programme
Note:
If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press
Start/Reload
.
a
The display shows either the pro-
gramme duration or the "Ready in"
time.
a
After the programme has ended,
the display shows: "End".
12.5 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
1.
Press
Start/Reload
.
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry while
the drum is rotating. If you want to
avoid or cancel the cooling pro-
cess, open the door.
→
2.
Open the appliance door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Start/Reload
.
12.6 Cancelling the pro-
gramme
1.
Press
Start/Reload
.
The cooling process starts auto-
matically after approx. 30 seconds
and cools down the laundry while
the drum is rotating. If you want to
avoid or cancel the cooling pro-
cess, open the door.
→
2.
Open the appliance door.
3.
.
12.7 Unloading the laundry
1.
Open the appliance door.
2.
Remove the laundry.
12.8 Switching off the appli-
ance
▶
Turn the programme selector to
Off
.
12.9 Fluff filter
During drying, fluff from the laundry is
collected in the fluff filter. The fluff fil-
ter protects the appliance from fluff.
Cleaning the fluff filter
If the drying programme has finished
or the display shows a notification
while the appliance is in operation,
clean the fluff filter.
Note:
If you do not clean the appli-
ance as described, the appliance's
functionality may be impaired.
Requirements
¡
The display shows the following
after drying: "End"
¡
or during operation: .
1.
Open the door.
2.
Remove the fluff from the door.
Summary of Contents for WQG24500BY
Page 55: ......
