Installation and connection
en
15
3.
Push the water drain hose as far
as it will go into the connecting
piece.
4.
Empty the condensation container
→
5.
Remove the stopper on the under-
side.
6.
Insert the stopper into the recess
in the top.
7.
Insert the condensation container
→
8.
Connect the appliance to the water
outlet.
→
"Water outlet connection types",
Tip:
To collect condensation in the
condensation container again (e. g. if
you change where the appliance is
located), carry out these steps in re-
verse order.
Water outlet connection types
ATTENTION!
In the event of a blocked or covered
outlet, accumulated wastewater can
flow back into the appliance.
▶
Before operating the appliance, en-
sure that the wastewater drains
away quickly and eliminate any
blockages.
Drainage into a
siphon.
Secure the con-
nection point with
a (12-22 mm)
hose clamp.
Secure the water
drain hose with a
hose guide at a
height of at least
80 cm and no
more than 100
cm.
Summary of Contents for WQG24590BY
Page 55: ......
