Appliance care
en
37
15.2 Preparing the condensa-
tion container for the ap-
pliance care programme
Note:
If the condensation is drained
using the drain hose, the condensa-
tion container must be prepared be-
fore the basic or intensive appliance
care programme.
→
1.
Remove the stopper from the re-
cess in the condensation con-
tainer.
2.
Insert the plug from below.
a
The condensation container is
ready for the appliance care pro-
gramme.
Note:
If the condensation is drained
using the drain hose, perform the
above-mentioned steps after the ba-
sic or intensive appliance care pro-
gramme in the reverse order.
15.3 Starting the appliance
care programme
Requirements
¡
The appliance is ready to run the
appliance care programme.
→
"Preparing the appliance for the
appliance care programme ",
Page 36
.
¡
The condensation container is
ready for the appliance care pro-
gramme.
→
container for the appliance care
programme", Page 37
.
1.
Set the programme to position 1.
2.
Press and hold
Iron Dry
.
3.
Set the programme to position 4.
4.
Release
Iron Dry
.
a
"CP1" and the programme dura-
tion alternate on the display.
15.4 Running the basic appli-
ance care programme on
the appliance
To remove any light soiling, you can
run a basic appliance care pro-
gramme.
Note:
After a certain period of use,
the appliance automatically recom-
mends that you run the basic appli-
ance care programme. Before the
start and end of the programme, the
display shows the note "CrE" for 5
