Appliance care
en
53
Running the basic appliance
care programme
To remove any dirt deposits in the
appliance, you can run the basic
appliance care programme.
Note:
After a certain period, your
appliance will automatically recommend
that you run the basic appliance care
programme.
’‘§“
will then appear on
the display for 5 seconds before the
programme starts, and again once the
programme ends. This message will
appear repeatedly until you have run the
basic appliance care programme
through to the end.
Run the appliance care programme as
follows:
1.
Prepare the appliance for appliance
2.
Set the programme to position 1.
3.
Press and hold
æ
(Iron Dry). At the
same time:
4.
Set the programme to position 4.
’˜‚
and the programme duration will
now alternate on the display.
5.
Pour approx. 1
^
litre of warm tap
water into the condensation
container.
Note:
Hold the full condensation
container horizontally at all times so
that no liquid spills out.
6.
Slide in the condensation container
until it clicks into place.
7.
Press
‹
(Start/Pause).
The appliance care programme will start
and an audible signal will sound.
“Ÿš
will appear on the display once the
appliance care programme has ended
and an audible signal will sound.
8.
Pull out the condensation container
horizontally and empty it.
#
+
3
;
#
+
3
;
