26
▯
If
Check drain
indicator lights up, check the drain
hose and its connection.
~
Maintenance of drain hose; Page 29
3.
If required, select
Low Heat
by pressing the button.
~
Additional options; Page 21
4.
If required, select
Wrinkle Block
by pressing the
button.
~
Additional options; Page 21
Tip:
The estimated remaining time will be updated.
Indicator of program sequence
The dryer uses an electronic control system. A moisture
sensor continuously checks the moisture in the laundry.
Drying ends automatically as soon as the selected
degree of dryness has been reached.
The drum continues to rotate at specific intervals for one
hour to prevent creasing.
The current state of the process and level reached during
the program sequence is indicated by indicator lights
(dry, damp, regular).
Childproof lock
You can secure the dryer against inadvertent changing of
the set functions. To do this, activate the childproof lock
after cycle start.
To
Activate/Deactivate
, press Start/Pause for approx. 5
seconds. In the display field, you will see the
D
symbol
light indicating the childproof lock is active.
NOTICE:
The childproof lock will remain activated until
the next cycle start even after switching the machine off.
You must deactivate the childproof lock before the next
cycle and, if necessary, activate it again after starting the
cycle.
Selecting a different program
If you have inadvertently started the wrong program, you
can change this as follows:
1.
Press Start/
Pause
.
2.
Select another program.
3.
Press
Start
/Pause. The new drying cycle starts from
the beginning.
Cancel program
If required, you can cancel the selected program:
1.
Press Start/
Pause
.
2.
Rotate the program selector to
Off
.
Program end
End
appears in the display area, the Start/Pause button
indicator lamp is off and the
regular
indicator lights up.
After the program end, rotate the program selector to
Off
.
Removing laundry/switching the
appliance off
1.
Open the door and remove the laundry.
2.
Turn the program selector to the
Off
position.
Appliance is switched off and dryer light goes out.
3.
Clean lint filter.
~
Cleaning the lint filter; Page 27
4.
Close the door.
Tip:
If at the end of the drying cycle the display does not
light, the energy-saving mode is active. To see diplay,
e.g. press any button.
~
Environmentally friendly use of your dryer; Page 7
Signal
For switching the buzzer on and off press the
Signal
button.
The Buzzer indicates program end if it is activated.
Other alarms are not influenced by this option.
