en
Cleaning
34
D
Cleaning
Cleaning
Cleaning the dryer and the
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.
Cleaning the moisture sensor
Note:
The dryer is equipped with a
stainless-steel moisture sensor. The
moisture sensor measures how damp
the laundry is.
After long periods of usage the moisture
sensor may become covered by a fine
layer of limescale or residues of
detergents and care products. Such
residues must be removed regularly as
the sensor function and in consequence
the drying result may be impaired.
Open the door and clean the moisture
sensor with a coarse sponge.
Caution!
Moisture sensor may be damaged.
Do not clean moisture sensors with
abrasives and steel wool.
Cleaning the filter
in the condensate container
Note:
The filter in the condensate
container cleans the condensation
water that is used during the dryer's
automatic cleaning cycle.
1.
Pull out the condensate container
horizontally.
2.
Pour out the condensation water.
3.
Remove the filter.
4.
Clean the filter under warm, running
water or in the dishwasher.
5.
Push in the filter until you feel it lock
into place.
Caution!
The dryer may be contaminated
with fluff and thus become
damaged.
Only operate the dryer with the filter
inserted.
6.
Push in the condensate container
until you feel it lock into place.