Environmental protection
en
11
:
Warning
Risk of injury/material
damage/damage to the
appliance!
The use of spare parts and
accessories supplied by other
brands is dangerous and may
result in injury, material damage
or damage to the appliance.
For safety reasons, use
genuine spare parts and
accessories only.
Caution!
Material damage/damage to
the appliance
Cleaning agents and agents for
pretreating laundry (e.g. stain
removers, prewash sprays, etc.)
may cause damage if they
come into contact with the
surfaces of the appliance.
Therefore please note:
■
Do not allow these agents to
come into contact with the
surfaces of the appliance.
■
Clean the appliance with
nothing but water and a soft,
damp cloth.
■
Remove any detergent,
spray or other residues
immediately.
7
Environmental
protection
Environmental protection
Packaging/old appliance
)
Dispose of packaging in an
environmentally-responsible manner.
This appliance is designated according
to European directive 2012/19/EC
which governs waste electrical and
electronic equipment (WEEE).
The directive provides a framework for
the collection and recycling of old
appliances, which is valid across
the EU.
Energy-saving tips
■
Spin the laundry before drying.
The drier the laundry, the shorter
the drying time will be, thus
consuming less energy.
■
Load the dryer with the maximum
load.
Note:
Do not exceed the maximum
load for the programs, as this
prolongs the drying time
and increases energy consumption.
■
Ventilate the room and keep the air
inlet on the dryer free to ensure air
exchange.
■
Clean the fluff filter after each drying
cycle. If the fluff filter is dirty,
the drying time is prolonged
and energy consumption is
increased.
■
Energy saving mode
: If the dryer is
not operated for a prolonged period,
it automatically switches off before
the program starts and when
the program has ended to save
energy. The display panel
and indicator lamps go off after
a few minutes and the Start button
flashes. To activate the lighting,
press any button, open or close
the dryer door or turn the program
selector.
