Cleaning
en
29
8.
The volume for the
audible button
signal
is shown in the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
9.
Press the "Ready in" time button
or the drying time button to change
the volume.
Exiting setting mode
Turn the programme selector to
the "Off" position once you have set
the required spin speed and
the volume. The settings have now
been saved.
D
Cleaning
Cleaning
Cleaning the dryer and the
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.
Cleaning the heat exchanger
Notes
■
Clean the heat exchanger several
times a month if you use the dryer
more than twice a week.
■
If there is debris in the heat
exchanger, this will increase the
amount of time required for drying
and will compromise the drying
results.
1.
Allow the dryer to cool down and
place an absorbent cloth beneath
the maintenance flap.
Note:
Residual water may leak out.
2.
Open the maintenance flap fully.
3.
Turn both locking levers towards
each other.
4.
Remove the top cap from the heat
exchanger.