20
Check heating system
1.
Check that the drum is empty.
2.
Close the dryer door.
3.
Switch the dryer to the
Cotton
program and select
Extra Dry
dryness level.
4.
Press the
Start/Pause
button.
5.
After 2-3 minutes press the
Start/Pause
button and
open the door.
▯
If the interior of the dryer feels warm, the dryer has
been connected properly. Press the center of the
Program Selector to switch off the appliance.
▯
If the dryer does not work, press the center of the
Program Selector to switch off the appliance. Look
in the Troubleshooting section of this user manual
for hints in solving the problem.
Preparing to transport the dryer - step by
step
1.
Press the center of the Program Selector to switch off
the appliance.
2.
Pull out power supply plug.
3.
Place any accessories in the drum.
4.
Close the door and secure with adhesive tape.
5.
Screw the height-adjustable feet of the dryer into the
housing to prevent them from being damaged during
transportation.
Reversing the door - step by step
Tip:
To reverse your dryer door side:
▯
Use only T20 (Torx) type screw driver to remove and
reinstall door screws.
▯
Do not use any other tools to reverse the door (hinge
or latch).
1.
Press the center of the Program Selector to switch
off
the appliance. Remove the power plug from wall
outlet. Open the door completely.
2.
Remove the hinge screws from the dryer side then
remove the door and hinge assembly from the dryer
housing.
3.
Place the door on a flat, smooth, secure surface such
as a towel or cloth lying on the floor or table.
4.
Remove screws from the hinge insert and then remove
it from the door.
