en
operation
26
12.4 Loading laundry
Note:
To prevent creasing, note the
maximum load for the programmes.
→
Requirements
¡
The laundry is prepared and sor-
ted.
→
¡
The drum is empty.
1.
Open the door.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
12.5 Starting the programme
Requirement:
A programme is set.
"Setting a programme", Page 25
▶
Press
.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows: "End" .
Note:
If "Hot" appears, the appli-
ance cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
12.6 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡
The programme is set.
→
"Setting a programme", Page 25
¡
The "Ready in" time is set and ac-
tivated.
→
1.
Press
.
The activated "Ready in" time is
paused.
2.
Press repeatedly until the dis-
play indicates the desired "Ready
in" time.
3.
Press
.
The changed "Ready in" time is ac-
tivated.
12.7 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Requirement:
A programme has
started.
→
1.
Press
.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
you want to avoid or cancel the
cooling process, open the door.
→
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
.
12.8 Cancelling the pro-
gramme
1.
Press
.
2.
Open the appliance door.
3.
Remove the laundry.
→
12.9 Unloading the laundry
1.
Open the door.
2.
Remove the laundry from the
drum.
Summary of Contents for WTH85VP6SN
Page 36: ...en Cleaning and servicing 36 2 Clean the moisture sensor with a sponge ...
Page 45: ......
Page 46: ......
Page 47: ......