en
Signal setting
30
M
Signal setting
Signal setting
You can change the following settings:
■
The spin speed that is used for
spinning your laundry before it is
dried,
■
The volume of the audible signal at
the end of the program,
■
The volume of the audible button
signals.
You will need to activate the setting
mode in order to change these settings.
Activating setting mode
1.
Switch the dryer on.
2.
Select the "Cottons" programme in
position 1 and wait for five seconds.
The symbols go out in the display panel
and the programme duration is
displayed.
1.
Press and hold the Start button and,
at the same time, turn the
programme selector clockwise to
position 2.
2.
The
spin speed
is shown in the
display.
3.
Press the "Finish in" time button or
the drying time button to change the
spin speed.
4.
Turn the program selector clockwise
to position 3.
5.
The volume of the
audible signal at
the end of the program
is shown in
the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
6.
Press the "Finish in" time button or
the drying time button to change the
volume.
7.
Turn the program selector clockwise
to position 4.
8.
The volume for the
audible button
signal
is shown in the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
9.
Press the "Finish in" time button or
the drying time button to change the
volume.
Exiting setting mode
Turn the program selector to the "Off"
position once you have set the required
spin speed and the volume. The
settings have now been saved.