Troubleshooting
en
37
Fault
Cause and troubleshooting
The length of the pro-
gramme changes dur-
ing the drying cycle.
The programme operation is optimised electronically.
This may change the programme duration.
▶
Not a fault – no action required.
Pumping noise.
Condensation pump active.
▶
Not a fault – normal operating noise.
Buzzing noise.
Compressor ventilation active.
▶
Not a fault – normal operating noise.
The drying time is too
long.
Fluff filter is soiled.
▶
"Cleaning the fluff filter", Page 28
The ambient temperature is greater than 30 °C.
▶
Ensure that the ambient temperature is lower than
30 °C.
The ambient temperature is lower than 15 °C.
▶
Ensure that the ambient temperature is above 15
°C.
Insufficient air circulation at the appliance's installation
location.
▶
Ventilate the appliance's installation location.
Appliance air inlet is blocked.
▶
Ensure that the air inlet on the appliance is kept
clear.
Heat exchanger is soiled.
1.
"Opening the base unit", Page 32
2.
Clean the heat exchanger.
→
"Cleaning the base unit", Page 32
3.
"Closing the base unit", Page 33
Water is leaking from
the appliance.
Appliance is not correctly aligned.
▶
Aligning the appliance
Water drain hose is not connected correctly.
▶
Ensure that the water drain hose is connected cor-
rectly.
→
"Connecting the water drain hose", Page 14
The laundry is too
damp.
Unsuitable programme for the type of fabric.
▶
Set a timed programme for the subsequent drying.
→
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
Summary of Contents for WTN85280GB
Page 43: ......