Faults and what to do about them
en
35
Note:
If you cannot rectify the fault yourself by turning the dryer off and on, please
contact our after-sales service.
Drying time too long?
■
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
ter.
■
The heat exchanger may be dirty and cause a longer drying time. Clean the
heat exchanger.
■
If the air inlet on the dryer is blocked or not freely accessible, this may
increase the drying time. Make sure that the air inlet remains unobstructed.
■
If the ambient temperature is higher than 35 °C, this may extend the drying
time.
■
Insufficient air circulation in the room may increase the drying time. Venti-
late the room.
Displayed drying time
changes during drying
process.
Not a fault. The dryer recognizes the load and adapts the remaining program
duration.
Humidity in the room
increases.
Not a fault. Make sure the room is sufficiently ventilated.
Power cut.
The drying program is interrupted. Remove the laundry and spread it out, or
restart the program.
Faults
Cause/remedy
* depending on the model
Summary of Contents for WTN8542SEG
Page 39: ...6 ...