en
Cleaning and maintenance
36
Cleaning the base unit
Fluff and hair from the laundry collect in
the base unit during drying. Clean the
appliance's base unit if the following
message appears in the display:
ç
.
You can also clean the appliance's
base unit even if this message does not
appear in the display, e.g. if there is
visible soiling.
:
Warning
Risk of injury!
You could cut your hands on the sharp
fins on the heat exchanger.
Do not touch the fins on the heat
exchanger with your hands.
Note:
Allow the appliance to cool down
for approximately 30 minutes after use
before commencing cleaning.
Clean the base unit as follows:
1.
2.
Open the maintenance flap by the
handle.
3.
Unlock the levers on the heat
exchanger cover.
4.
Pull the heat exchanger cover out by
its grip.
5.
Carefully remove the filter mat from
the heat exchanger cover.
Note:
Take care not to damage the
filter mat when doing this.
6.
Use a soft brush to clean the heat
exchanger cover.
Note:
Make sure that no dirt or
debris is left on the seal.
7.
Rinse the filter mat under running
water and squeeze out the water
with your hand.
Notes
– If there are heavy deposits, you
can clean the filter mat carefully
with a vacuum cleaner.
– Only clean with clear water; do
not use cleaning products.
