Programmes and buttons
en
15
Buttons
--------
Buttons
Explanations and notes
Note:
Not all buttons and their functions can be selected in all programmes.
E
child lock push
3 sec
You can activate or deactivate the childproof lock by pressing and holding the child-
proof lock button for three seconds.
Q
Easy-Iron
60 min
The drum moves the laundry at regular intervals after drying to prevent creasing. You
can extend the automatic Anti-Crease function by 60 minutes after any programme
has finished.
Q
Easy-Iron
120 min
The drum moves the laundry at regular intervals after drying to prevent creasing. You
can extend the automatic Anti-Crease function by 120 minutes after any programme
has finished.
s
Low Heat
Reduced temperature for delicate fabrics, e.g. polyacrylic or elastane, may increase
the drying time.
C
end signal
An audible signal sounds after the programme has ended.
Ê
Drying target
: Select the dryness level according to the laundry to be dried.
If you have selected a dryness level, this is stored for all programmes, except for Cot-
tons, even after the dryer has been switched off.
Ò
Cupboard Dry
Plus
Multi-layered, thick laundry that does not dry readily.
±
Cupboard Dry
Normal, single-layered laundry.
ö
Iron Dry
Normal, single-layered laundry that still needs to be damp after drying and is suitable
for ironing or hanging up.
–
Fine adjust
If the laundry is too damp after drying, you can finely adjust the dryness levels e.g.
Cupboard Dry. The dryness level can be increased with the degree of dryness in
three stages, from
ˆ
to
ˆˆˆ
.
If you have adjusted the dryness level, the setting for all programmes with a selecta-
ble dryness level is retained even after the dryer is switched off.
ð
- Finished in +
The programme will end in between 1 h and 24 h. Set the "Ready in" time in incre-
ments of one hour to delay the start of the programme. The required number of
hours after the programme ends is displayed on the display panel.
The drying time for timed programmes can be set to between 10 minutes and 3
hours and 30 minutes, in 10-minute increments.
A
Start/Pause
Starts or pauses the programme.
