en
Safety instructions
6
Installation
:
Warning
Risk of electric shock/fire/
material damage/damage to
the appliance!
If the appliance is not installed
properly, this may lead to a
dangerous situation. Ensure
the following:
■
The mains voltage on your
power socket must match
the rated voltage specified
on the appliance
(identification plate). The
connected loads and the
required fuse protection are
specified on the identification
plate.
■
The appliance must not be
supplied through an external
switching device, such as a
timer, or connected to a
circuit that is regularly
switched on and off by a
utility.
■
The mains plug and the
protective contact socket
must match and the earthing
system must be correctly
installed.
■
The installation must have an
adequate cross section.
■
The mains plug must be
freely accessible at all times.
If this is not possible, in
order to comply with the
relevant safety regulations, a
switch (all pole
disconnection) must be built
into the permanent
installation in accordance
with electrical installation
regulations.
■
If using a residual current
circuit breaker, only use one
that bears the following
mark:
z
. The presence of
this mark is the only way to
be sure that it fulfils all the
applicable regulations.
:
Warning
Risk of electric shock/fire/
material damage/damage to
the appliance!
If the appliance's mains cable is
altered or damaged, this may
result in electric shock, short
circuiting or fire due to
overheating.
The mains cable must not be
kinked, crushed or altered, and
must not come into contact with
any heat sources.
Summary of Contents for WTW85231GB
Page 39: ...6 ...