en
Troubleshooting
38
Fault
Cause and troubleshooting
Pumping noise.
Condensation pump active.
▶
Not a fault – normal operating noise.
Buzzing noise.
Compressor ventilation active.
▶
Not a fault – normal operating noise.
The drying time is too
long.
Fluff filter is soiled.
▶
"Cleaning the fluff filter", Page 28
The ambient temperature is greater than 30 °C.
▶
Ensure that the ambient temperature is lower than
30 °C.
The ambient temperature is lower than 15 °C.
▶
Ensure that the ambient temperature is above 15
°C.
Insufficient air circulation at the appliance's installation
location.
▶
Ventilate the appliance's installation location.
Appliance air inlet is blocked.
▶
Ensure that the air inlet on the appliance is kept
clear.
Automatic self-cleaning function rinses the appliance's
heat exchanger.
1.
Not a fault.
2.
Do not pull out the condensation tank.
3.
Do not cancel the programme.
Water is leaking from
the appliance.
Appliance is not correctly aligned.
▶
"Aligning the appliance", Page 16
Water drain hose is not connected correctly.
▶
Ensure that the water drain hose is connected cor-
rectly.
→
"Connecting the water drain hose", Page 14
The laundry is too
damp.
Unsuitable programme for the type of fabric.
▶
Set a timed programme for the subsequent drying.
→
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The load is too large.
▶
Observe the maximum load capacity of the
→
.