Bosch WTW854S9SN, Installation And Operating Instructions Manual

Faults and what to do about them       

en

35

3

 Faults and what to do about them

Faults and what to do about them

Faults

Cause/remedy

ð

 on the display panel 

and drying has been 

interrupted.

■

Empty the condensate container; 

~

 Page 31

and the dryer; 

~

 Page 16

.

■

If the optional condensation drain* is installed, the drain hose may be 

blocked or kinked. Check the hose for deposits and rinse the hose. Lay 

the hose without any kinks.

é

 on the display panel. Clean the fluff filter and press the Start button 

~

 Page 30

.

selfCleaning on the 

ó

display panel.

Not a fault. The heat exchanger is cleaned automatically. Do not pull out 

the condensate container while this is displayed.

Dryer does not start.

■

Mains plug plugged in or fuse checked?

■

Programme selected? Select a programme.

■

Dryer door open? Close the door.

■

Is the childproof lock activated? Deactivate the childproof lock.

■

"Ready in" time selected? Programme starts after a delay 

~

 Page 27

.

Creasing.

■

Creasing occurs when you have exceeded the maximum load or selected 

the wrong programme for the type of fabric. All the required information 

can be found in the programme table 

~

 Page 25

.

■

Remove clothes immediately after drying; creasing may occur if they are 

left in the drum.

Water is leaking out.

Not a fault; the dryer may be positioned on an incline. Level the dryer.

Change in the pro-

gramme duration dis-

played during drying.

Not a fault. The moisture sensors detect the remaining moisture in the load and 

adjust the programme length (except timed programmes).

Laundry is not dried cor-

rectly or is still too damp.

■

After the end of the programme, warm laundry feels damper than it actually 

is. Spread the laundry out and allow the heat to disperse.

■

Finely adjust the dryness level – this extends the drying time but does not 

increase the temperature. Your laundry will become drier 

~

 Page 27

.

■

Select a programme with a longer drying time or increase the drying level. 

This does not increase the temperature.

■

Select a timed programme for subsequent drying of laundry that is still 

damp 

~

 Page 25

.

■

If you have exceeded the maximum load for the programme, the laundry 

may not be dried properly.

■

Clean the moisture sensor in the drum. The sensor may become covered by 

a fine layer of limescale or residues of detergents and care products which 

then impair its function. Your laundry is not being dried correctly 

~

 Page 34

.

■

Drying has been interrupted as a result of a power cut, because the conden-

sate container is full or because the maximum drying time has been 

exceeded.

Note:  

See also the laundry tips 

~

 Page 24

.

* Depending on the model