Faults and what to do about them
en
23
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
ð
on the display panel
and drying has been
interrupted.
■
Empty the condensate container and press the Start button
■
If the optional condensation drain* is installed, the drain hose may be
blocked or kinked. Check the hose for deposits and flush the hose out. Lay
the hose without any kinks.
é
on the display panel. Clean the fluff filter and press the Start button
.
SelfCleaning on the
’
display panel.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out the
condensate container while this is displayed.
Dryer does not start.
■
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong programme for the type of fabric. All the required information
can be found in the programme table
■
Remove clothes immediately after drying; creasing may occur if they are
left in the drum.
Water is leaking out.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Laundry is not dried cor-
rectly or is still too damp.
■
After the end of the programme, warm laundry feels damper than it actually
is. Spread the laundry out and allow the heat to disperse.
■
Finely adjust the dryness level – this extends the drying time but does not
increase the temperature. Your laundry will become drier
■
Select a programme with a longer drying time or increase the drying level.
This does not increase the temperature.
■
Select a timed programme for subsequent drying of laundry that is still
damp
■
If you have exceeded the maximum load for the programme, the laundry
may not be dried properly.
■
Clean the moisture sensor in the drum. A fine layer of limescale may
adversely affect the performance of the sensors and your washing will not
.
■
Drying has been interrupted as a result of a power cut, because the conden-
sate container is full or because the maximum drying time has been
exceeded.
Note:
See also the laundry tips
* depending on the model
